The Applications screen
Only applicable to Configuration Manager, displays the statistics of WakeUp behavior in relation to Configuration Manager Application Assignments that have been sent. The Application Assignments table displays the successful wake ups for each Application Assignment sent to clients of this particular Configuration Manager site.
Explaining the Software Distribution Advertisements, Software Update Assignments and Application Assignments table columns
Table column | Explanation |
|---|---|
Advertisement | Lists the name of the Configuration Manager Advertisement, Software Update Assignment or Application Assignment. |
Queued | The queued wake ups for the Advertisement, Software Update Assignment or Application Assignment. |
Sent | Lists the total number of wakeups sent. |
Not Sent | Indicates an error; i.e. no TCP route to the computer was found |
Awake | Lists the number of target computers which were already on when the active 1E Agent sent out magic packets. Only available in Multi-Agent mode |
Woke Up | Lists the number of target computers woken up in response to magic packets. Only available in Multi-Agent mode |
No Agent | Lists the number of computers which were awake already but without a 1E Agent installed |
Failed | After sending magic packets, the 1E Agent waits for a pre-determined time for replies. Any computers which have not responded are sent an ICMP ping. computers responding to this are classified as No Agent (they are awake, but WakeUp cannot be certain if this is due to a magic packet or if the computer was awake already. Also, the 1E Agent may not have been installed). computers not responding to the ping are classified as Failed. |
Last Run Time | Lists the last time the recurring Advertisement, Software Update Assignment or Application Assignment ran. |
Refresh | Updates the Advertisement, Software Update Assignment or Application Assignment table. |
The console reporting can be enabled or disabled by checking the Enable Agent Reporting checkbox in the Communications screen.
Note
If 1E Agent reporting is disabled, WakeUp reports are unavailable.
Configuring 1E Agents
In general, 1E Agents are configured at install time (see installing the 1E Agent. You can, additionally, set wake up parameters for 1E Agents at runtime using the WakeUp Server console.